Vatech PCH-30CS - Installing Emergency Stop Switch

9. Installing Software
116 PaX-i Plus / Insight Installation Manual
Selecting an Announcement Mode: Music or Beep (Optional)
When the need to select an announcement between music and beep arises, take
following procedures.
Commands specifications:
Command format: [SPM_MPOP_XXXX]
XXXX Imaging Modes
Announcement
Mode
Division
0000
PANO/CEPH
Music
Different for each mode
0001
PANO/CEPH
Music
The same for each mode
0002
(Default)
PANO/CEPH Beep
The same for each mode
1. Send the command in accordance with the command specification, as specified in the
table above.
Here are some examples.
Default mode: 0002(b eep) for each imaging mode.
< When the same Music Announcement is desired for PANO and CEPH imaging
modality >
: Enter the command [SPM_MPOP_0001] in the command field, followed by Send.
< When the same Beep Announcement is desired for PANO and CEPH imaging
modality >
: Enter the command [SPM_MPOP_0002] in the command field, followed by Send.