Operating & Mounting instructions – 8 074 143.03/03 – Page 71
Projecting
Mains fuses and cable diameters
1.) 2.) 1.) 4.) 5.) 1.) 1.) 3.)
Mains ssupply Frequency iinverter Motor-
output
Pre-oor Mains ffuse Lines iin tthe Max. CConnec-MMotor
conduit Cu ccable “inverter cubicle >pDRIVE< contin. tion cable
fuses protection” ““sf” (per pphase) current
40 A 3x6 mm
2
32 A 6 mm
2
CX profi 11 22 A M6 3x6 mm
2
50 A 3x10 mm
2
40 A 10 mm
2
CX profi 15 29 A M6 3x6 mm
2
63 A 3x16 mm
2
50 A 10 mm
2
CX profi 18 37 A M6 3x10 mm
2
63 A 3x16 mm
2
50 A 10 mm
2
CX profi 22 43 A M6 3x10 mm
2
80 A 3x25 mm
2
63 A 10 mm
2
CX profi 30 57 A M6 3x10 mm
2
100 A 3x35 mm
2
80 A 16 mm
2
CX profi 37 70 A M6 3x16 mm
2
K
ey to table:
1. The cable diameter indicated in the table are an index for laying the cable in air at max. 40°C,
based on the ÖVN EN 1 and VDE 0100 regulations.
For other ambient conditions and different regulations, the cable diameters must be
adjusted accordingly.
2. Pre-fuses calculated for DOL starting with bypass circuit.
3. The motor cables are designed for the maximum continuous current at an ambient temperature
of 40°C and laid in air. When a bypass circuit is used, the motor cable must be designed for the
value of the pre- or condiut fuses!
The use of NYCY or NYCWY cables for the motor cables (power cables with concentric protection
core) is a low-price alternative to screended cables.
4. In case of a trip, sf fuses protect the inverter from secondary damage in the rectifier, the charging
circuit etc.
The mains fuses represent a secondary protection of the inverter in the case of failure of the
electronic protection. However, if this fuses are blown, a primary defect has already occurred
inside the unit. Therefore, changing
the blown fuses and switching the inverter on again is not
effective. Furthermore, it is not advantageous to use circuit breakers. This has the disadvantage of
a slower switch-off.
5. If the inverter is used without
line choke (CE-DR filter) the fuses must be selected one type higher
to protect the inverter.