25
Eng
11,
PROGRAMMING THE DOSES
(O N LY FO R T H E AU TO MAT IC VE RS IO N).
You can store the amount of coffee dispensed for all the buttons on the selector knob, except the continuous dispensing button
“
”.
WARNING: Programming the first selector knob on the left, the other selector knobs on the machine will
automatically be programmed.
You can also customise the amount of coffee dispensed for each selector knob by repeating dose programming
for each single one.
• Mount the filer holder containing coffee on the unit (see the paragraph OPERATION).
• Place one or two cups on the cup holder grille depending on what you want to program.
• Press the button “
” and hold it pressed down for at least 5 seconds until the relative LED comes on flashing indicating
that you have entered programming.
• Press the button “
” to be programmed within 5 seconds to start coffee dispensing; the LED on the button “ ” will
continue flashing and the LED on the button “
” pressed will stay on fixed, while all the other LEDs on the other buttons
“
”, “ ”, “ ” will go off.
• Once you have reached the desired amount of coffee, press the button previously selected again to stop dispensing; the relative
LED will go off indicating that the amount of coffee has been stored and the other LEDs on the buttons still to be programmed
will come on.
• Repeat the same operations for the other buttons “
”, “ ”, “ ” on the selector knob; if the buttons are not used
for 5-6 seconds, the machine automatically exits programming.
Manuale_LOLLO_Rev1_5lingue-Cinese_07-2016.indd 25 22/08/16 16:08
To Next Page
Loading...
