30
2
1
3
3
1
ENG
12.4,
DISPENSING STEAM.
• Turn the steam nozzle (1) towards the drip tray and dispense briefly into the tray by slowly moving the tap lever (2) horizontally
or vertically in order to remove any residual water present in the circuit.
The nozzle (1) is very hot.
Only move the nozzle gripping it by its rubber protection (3) as there is a risk of scalding yourself.
• Move the steam nozzle (1) to the outside and then put a cup or a jug full of liquid to be heated underneath the nozzle (1).
• Fully immerse the spout of the steam nozzle into the liquid and slowly open the tap (2) by moving the lever vertically or
horizontally.
• Once the desired temperature has been reached, close the tap (2) by moving the lever back into central position.
• Turn the steam nozzle (1) towards the drip tray and dispense briefly into the tray to clean the inside of the nozzle and then clean
the outside with a moist cloth to prevent encrustations difficult to remove.
Manuale_LOLLO_Rev1_5lingue-Cinese_07-2016.indd 30 22/08/16 16:08
To Next Page
Loading...
