VDO BVDR - Overspeed Warnings and USB Write Error Solutions

Issue 02/2017 © Continental Automotive 49
Screen
Error, Possible Causes, Solutions and
Comments
Comments
This message is not an error message, but
a warning that the date and time may have
been modified. This is normal in the case of
use of the daylight saving time and winter
time function.
Meaning
Code 14 – Over speed warning
This message appears when the configured
speed limit was exceeded.
Possible causes
Speed above the set limit.
Solution
Do not exceed the speed limit.
Comments
This message is not an error message, but
a warning that the programmed speed limit
has been exceeded.
Meaning
Code 16 - Writing Error on USB memory
This message appears when the data from
the tachograph memory was not recorded
on a USB Flash drive.
Possible causes
USB disk write protection is on.
USB disk is defective.
BVDR USB connector is defective.
Solution
Repeat the procedure for writing data;
Change the Flash Drive.
Comments
If the fault persists, contact an authorized
VDO workshop.