Vdwall LVP615S - Page 35

LVP615S
使用说明
35
knob
Setup
OK
↓
OK
2.Input video signal
2.6 switch mode Pre.+Take SW. ？
port to YPbPr.
Operation steps
：
In the menu of 2.5 V2 or YPbPr，rotate
parameters and press “OK” to make them effective.
to select needed
6.2.4 Signal switch mode
Press to enter setup menu， press ↓ to select “2. Input video
signal”，Then press to enter“2.input video signal ”，and press to
select signal switch mode“one key switch ”or Pre.+Take
switch ”,Press to apply.
2.1
DVI EDID
1280x1024_60
2.2
V1/V2 backup
off
2.3
VGA1/VGA2 backup
off
2.4
HDMI/DVI backup
off
2.5
V2 or YPbPr
V2