Appendix A - EMR3 Setup - Programming Tips For Typical Single or Dual-head Installations with One IB
A-3
19 Relay Control (Non-C&C, ref.
Figure 14 on page 16)
This is where the relays “volume to go” for 2-stage presets are adjusted.
Defaults are 5 and 0.1. You may want to change 5 to 3.
20 Tank ID
• Enable under C&C Delivery
Options/Tank ID (ref. Figure 47
on page 43)
• Enter Tank ID under C&C
Language/Label Changes/
Setup Labels/Tank ID (ref.
Figure 32 on page 30)
• Change Tank ID default under
C&C Language/Label Changes/
Setup Labels/Tank ID Default
(ref. Figure 32 on page 30)
If enabled, you are required to enter an ID for each delivery.
21 View Records (Non-C&C, ref.
Figure 18 on page 20)
You can view and print up to the last 50 transactions.
22 Shift Report ((Non-C&C, ref.
Figure 20 on page 22)
This is where the Shift Report capability can be accessed. Between the
“Accept” Start and “Accept” End times you get a summary of the transac-
tions. You can also enter Load and Odometer information. Load informa-
tion is adjusted by the transactions.
23 Shift Report Format (C&C Report
Formats ref. Figure 48 on
page 44)
If you want a special Shift Report then set it up in the same way as the
Delivery Report/Ticket.
24 Date Format (Non-C&C, ref.
Figure 22 on page 23)
If you want a date format other than the default.
25 Time/Date (Non-C&C, ref.
Figure 23 on page 24)
Set date and time format other than the default.
26 System Address (Non-C&C, ref.
Figure 24 on page 24)
Defaults okay for typical truck with two heads noted above. Terminal
installations with more than one IB, consult V-R.
27 Pricing (Non-C&C, ref. Figure 9
on page 14)
Not available if display does not have optional Currency feature installed.
28 Tax/Discount (Non-C&C, ref.
Figure 10 on page 14)
Not available if display does not have optional Currency feature installed.
29 Version Number (Non-C&C, ref.
Figure 31 on page 28)
This is a read-only system. These numbers are the official W&M software
numbers.
30 Restore Records (Non-C&C, ref.
Figure 19 on page 21)
Only to be used in special cases.
31 Restart (C&C, ref. Figure 50 on
page 45)
CAUTION! DO NOT USE FOR NORMAL OPERATION - WILL REBOOT
DISPLAY TO FACTORY SET DEFAULTS AND YOUR SETUP INFOR-
MATION WILL BE ERASED.
Order Activity Comment
To Next Page
Loading...
