Vega MINITRAC 31 Installation & Maintenance Instructions

42
6 Set up with the display and adjustment module
MINITRAC 31 • 4 … 20 mA/HART - four-wire
40447-EN-130430
Process value
Current output
Switching function of the relay
Information:
The simulation is terminated automatically 60 minutes after the last
key has been pushed.
Additional settings
In this menu item, the PIN is permanently activated/deactivated. Thus
youprotectthesensordataagainstunauthorizedaccessandunin-
tended changes. The default setting of the PIN is 0000.
This parameter is described in the operating instructions manual
"Display and adjustment module".
In this menu item you can set the actual date and time.
This parameter is described in the operating instructions manual
"Display and adjustment module".
When a reset is carried out, all settings (with only a few exceptions)
are reset. The exceptions are: PIN, language, SIL and HART mode.
The following reset functions are available:
Basic adjustments: Resetting of the parameter adjustmetns to
defaultvaluesatthetimeofshipment.Order-specicsettingswillbe
deleted.
Default settings: Resetting of the parameter adjustment like under
"Basic adjustment". In addition, special parameters will be reset to
defaultvalues.Order-specicsettingswillnotbedeleted.
Additional adjustments/
PIN
Additional adjustments/
Date time
Additional adjustments/
Reset

Vega MINITRAC 31 Specifications

General

Brand	Vega
Model	MINITRAC 31
Category	Accessories
Language	English