VELMEX VXM-3 - Page 56

J
Mtr1&2
No
Function
Mtr
1
Mtr
2
NOTE:
Pin5removed
setjA
setJA
Primary/SecondarySpeeds
(Input2)
ToVXMAuxiliaryI/O
+
(Input3)
Analog Joystick with One VXM
TheoptionalanalogjoystickcanbeusedwithasingleVXMcontrol.
ThejoystickprovidesanalogoutputsfortwoVXMcontrols. WithasingleVXMoneoutput
isnotconnectedresultingin“nofunction”intheonedirectionofthejoystick.
TheanalogjoystickhasabuttonswitchconnectedtoInput2
fortogglingbetweenthe
primaryandsecondarysettablejogspeeds.
ThereisalsoasecondbuttonswitchconnectedtoInput3foralternatingbetweenmotors
1and2.
Thedefaultprimaryandsecondaryspeedsarebydefaultbothsetto0(disabled
joystick.)
NOTE: Itispossibletodisable/removethebuttonswitch(es)ifInput
2andInput3are
neededforanotherfunction. Todisable/removethebutton(s),withthebuttonintheout
position,useplierstopullthebuttoncapofftheswitchactuator.Theswitchactuator
shouldnowbebelowthesurfaceenoughtopreventunintendedinput. Analternate
methodtodisablethebutton
switchesisbyclippingoffpin6andpin7onthecables
connector.
NOTE:
5
Straightthroughcablepins
9and15notrequiredand
pin5mustberemoved