9
2.
Controls (cont’d)
2.3 Deco-Touch Main Control
OPERATING MODES
OFF
PUT THE UNIT ON STAND-BY MODE, SO IT WILL ONLY RESPOND TO AUXILIAIRY
CONTROLS (IF PRESENT). ON LCD SCREEN, ONLY THE HOUSE IS VISIBLE
SHOWING THE CONTROL IS POWERED ON. THIS IS THE FACTORY DEFAULT
MODE.
RECIRC
AIR IS RECIRCULATED INSIDE THE HOUSE AT HIGH SPEED.
TO CHANGE THE OPERATION MODE OF THE VENTILATION UNIT, PRESS THE
UP OR DOWN ARROW BUTTON. OPERATING MODE LABEL WILL THEN
SCROLL UP OR DOWN ON LCD SCREEN.
20 MIN/H
THE VENTILATION UNIT EXCHANGES AIR INTERMITTENTLY ON A ONE
HOUR CYCLE AS FOLLOWS: OFF FOR 40 MIN. (OR RECIRCULATION ON
HIGH SPEED FOR 40 MIN., SEE NEXT PAGE) AND THEN EXCHANGE AIR
DURING 20 MIN. ON LOW SPEED. REPEAT CYCLE AFTER THE 20 MIN. OF
AIR EXCHANGE.
MIN
AIR IS EXCHANGED WITH THE OUTSIDE ON LOW SPEED.
MAX
AIR IS EXCHANGED WITH THE OUTSIDE ON HIGH SPEED.
BACKLIGHT
IF THE BACKLIGHT IS NOT ILLUMINATED, THE FIRST BUTTON PRESSED
(NO MATTER WHICH BUTTON) SHALL TURN ON THE BACKLIGHT. THE
BACKLIGHT REMAINS ILLUMINATED FOR 10 SECONDS AFTER THE
LAST BUTTON PRESSED.
To Next Page
Loading...
Need help?
General
