Overview Give us your thoughts
Ver-Mac 2018 PCMS Operations, Safety & Maintenance V3.0 3
4. Type of hoist (hydraulic lift or reversible hand winch) to raise the mast.
5. Peripheral devices attached to the PCMS unit.
6. PCMS unit components not manufactured by Ver-Mac.
For detailed information on the maintenance requirements of any PCMS unit
component assembled by, but not manufactured by Signalisation Ver-Mac,
please consult the relevant manufacturer’s Maintenance manual.
1.4 Troubleshooting
When contacting support please make sure to have the following:
Be at the unit when contacting support.
Make sure to bring a voltmeter.
The serial number will be requiring for troubleshooting.
1.5 About Replacement Parts
Replacement parts for PCMS may vary according to models. To know the correct
replacement part:
See the PCMS Parts Manual for your unit or contact Ver-Mac Support for further
information.
Before calling Ver-Mac for assistance, please make sure you have the
identification number of your PCMS in hand.
o Vehicle Identification Number (VIN) is on the tongue of the trailer.
o Serial number is on the PCMS panel or in the control box.
1.6 About Maximum Speeds
Ver-Mac recommends a maximum towing speed of 90 km/h (55 mph) for a trailer-
mounted PCMS moving to or from worksites, in transport mode only.
Always install the trailer in transport mode before leaving. Pulling
a trailer in operating mode could cause permanent damage to
the structure.
Ver-Mac does not recommend the use of a trailer-mounted PCMS in mobile
operations.
Vehicles with racks or other vehicle-mounted PCMS can be driven at these speeds:
Up to 110 km/h (70 mph) with the sign in the transportation position.
Up to 55 km/h (35 mph) with the sign deployed.
To Next Page
Loading...
