Unit Deployment and Removal Give us your thoughts
Ver-Mac 2018 PCMS Operations, Safety & Maintenance V3.0 7
3 Unit Deployment and Removal
When you are working at the roadside you must always remain alert to your surroundings and
the traffic behavior.
Be safe. Stay alert and pay close attention to the surrounding
traffic at all times.
3.1 Trailer Deployment
Be very careful when attempting to maneuver trailer into position
for setting up.
1. Position the trailer as close as possible to the location with the tow vehicle
2. Set one (1) jack in position and block the trailer wheels before you start to
disconnect the coupler from the tow vehicle hitch
3. Unplug the power connection to the tow vehicle and store plug in the optional
holder, if available
4. Unhook breakaway cable (if trailer is equipped with brakes)
5. Detach the safety chains
6. Check the ground conditions and install all the jacks
Make sure the wheels are off the ground and trailer is as level as possible
Add blocks under the jack pads as needed.
To Next Page
Loading...
