VER-MAC PCMS Series - Jacks Periodic Maintenance; Trailer Lights and Reflectors

Trailer Maintenance Give us your thoughts
12 PCMS Operations, Safety & Maintenance V3.0 Ver-Mac 2018
4.4.1 Jacks Periodic Maintenance
Item
Function Required
Before
Each Use
3 Months
12 Months
Jacks
Tubular Swivel
(4)
Clean dirt, mud or tar from jack
•
•
Extend jack as far as possible and lubricate
entire outside length of inner ram with SAE
30 heavy oil
•
Grease each jack
(grease fitting at top of outer ram)
•
Outriggers
Remove any corrosion, rust and dirt
•
•
Ensure safety pins are attached and in
position
•
•
4.5 Trailer Lights and Reflectors
Trailer lights perform a valuable and necessary function, but they occasionally
breakdown or malfunction. All Ver-Mac trailers come equipped with:
 brake lights
 tail lights
 turn signals (left and right)
 marker and clearance lights
Marker lights enhance the visibility of the trailer at night. They are positioned on the
sides of the trailer frame (amber toward the front and red to the rear).
As well, three (3) red clearance lights are in the center of the back bar on trailers wider
than 80″ (203cm).
NOTE
Check that the plug on the tow vehicle matches the trailer wiring end plug on the
trailer.
CAUTION
Always test all trailer lights before towing.
Make sure wiring is properly installed and secured to trailer to prevent
it from hanging and catching on any road debris.
4.5.1 Replacement Light Bulbs
Make sure that any replacement light bulbs are 12V DC.