VER-MAC PCMS Series - Raising Mast with Hand Winch; Lowering Mast with Hand Winch; Replacement Winch Cable

Mast Maintenance Give us your thoughts
Ver-Mac 2018 PCMS Operations, Safety & Maintenance V3.0 29
9.3.1 Raising Mast
1. Disengage the locking pin on the mast
2. Slowly and evenly turn the crank handle clockwise  and raise the mast to
its full height
This action produces an audible clicking sound from inside the winch
mechanism
3. Release the handle slowly to lock the mast in position
4. Make sure the locking pin on the mast is fully inserted and locking the mast
in position
WARNING
Keep hands and fingers clear of the drum and cable area of the
winch when operating.
Do not attempt to guide cable by hand.
CAUTION
Never continue turning the handle counter-clockwise if the cable
does not keep moving out.
This disengages the winch brake mechanism and can create an
unsafe or hazardous condition.
9.3.2 Lowering Mast
1. Disengage the locking pin on the mast
2. Slowly and evenly turn crank handle counter-clockwise and lower the
mast until the signboard is resting in the transportation cradle
3. Reverse the movement and turn crank handle clockwise  approx. 20
cm/8”. This action locks the mast in position.
4. Pull and turn the locking pin on the mast to the locked position.
NOTE
The winch brake prevents the handle from spinning rapidly backwards if ever
your hand slips off the winch handle while lowering the mast.
CAUTION
The winch brake is not fully locked until you hear at least two (2)
clicks of the ratchet. Only then do you release the handle.
9.3.3 Replacement Winch Cable
CAUTION
Always replace winch cable with one that is identical in diameter and load
limit.
Replacement Procedure for Winch Cable