INTRODUCTION
B001167
PRIORITY OF RECEIVED SIGNALS
Sensors and engine
• Two analogue resistive inputs
• Analog frequency input
• NMEA 2000
• LIN bus for Intelligent Battery Sensor (IBS)
GPS position
• Integrated GPS module
• NMEA 2000
SWITCHING ON AND OFF
The on/off mode depends on the ignition signal on terminal 15 (Molex-connector pin 7).
At power up, the tachometer and warning lights come on for two seconds, the Veratron logo appears and
then the last data page displayed before powering off.
You can customize the loading image displayed at power up using the Veratron Configuration Tool.
Note: Contact your veratron dealer for more information.
To Next Page
Loading...