PERFORMING DOWNLOADS
Back-to-Back Application Downloads
122 V
X
810 REFERENCE GUIDE
Download Application Files to Receiving Device
1 Configure a sending device for an application download operation to a
deployment device:
• If the *FA variable (if present in the application) is set to 0, you can reset it
to 1. For more information on the *FA variable, refer to the Verix V
Programmers Manual.
• Ensure that the download is exactly what you want your receiving devices
to receive.
• Ensure that previously authenticated files are not changed prior to the file
transfer operation.
2 Configure the receiving device to receive an application download from the
sending device. From
SYS MODE MENU 1, set Group 1 and COM2 as the port to
receive the file transfer.
3 Connect a cable, VPN 08362-01-R, between the RS-232 serial ports of the
source and receiving devices
using a UART Dongle connected to each device.
4 From any system mode menu on the sending device, press [*] and enter the
GID1 password to initiate the file transfer.
5 From SYS MODE MENU 1 on the deployment device, select either a full or a
partial download. The sending device begins to transfer files to the receiving
device.
To Next Page
Loading...
