V
X
810 REFERENCE GUIDE 139
APPENDIX A
System Messages
This appendix describes system messages, which are grouped into two
categories: error messages and information messages.
Error Messages
The following error messages may appear when the V
x
810 device is in system
mode.
This message displays when
DEBUGGER F5 in SYS MODE MENU 2 is selected and
the debugging monitor program, DBMON.OUT, is already running on the device.
A corrupt file is detected in the flash ROM file system during device start up, after
power on, or during restart. This message may indicate a hardware problem; the
error condition may be resolved through another download of the file.
This message is displayed if you enter an incorrect system mode password or an
incorrect file group password. Repeat the password entry and press
ENTER.
A corrupt file is detected in the SRAM file system at device start up, after power-
on, or during restart. This message may indicate a hardware problem; the error
condition may be resolved through another download of the file.
If you are using the file compression module in DMM, information similar to what
is shown above appears when an error occurs during file extraction from a
downloaded ZIP archive. Note the error number and error codes (
XXXXX and
YYYYY) and try to download the archive again.
ALREADY DEBUGGING
FLASH CHKSUM ERROR
PLEASE TRY AGAIN
RAM CHKSUM ERROR
** UNZIP ERROR N
XXXXXX
YYYYYY
To Next Page
Loading...
