Verizon CE1000A - Factory Reset and Rebooting

58
 / TROUBLESHOOTING
©2023 Verizon. All Rights Reserved
• Access Control - If the access control setting for the computer is
set to block the computer, access to your Verizon Wi-Fi Extender
is denied.
To gain access, restore the default settings to your Extender.
5.0d/ RESTORING YOUR VERIZON WIFI EXTENDER’S
DEFAULT SETTINGS
There are two ways to restore your Verizon Wi-Fi Extender’s
default settings. It is important to note that after performing
either procedure, all previously saved settings on your
Verizon Wi-Fi Extender will be lost.
• Using the tip of a ballpoint pen or pencil, press and hold the
Reset button on the back of your Verizon Wi-Fi Extender for at
least ten seconds.
• Access the UI and navigate to the Advanced Settings page.
Select the Factory Reset option. Click the Restore Default
Settings button. For additional details, refer to the section 2.2c/
Factory Reset section of this guide.
Note: If you reset or reboot your Verizon Wi-Fi Extender, you may
also need to disconnect your Verizon Wi-Fi Extender’s power supply
for a few minutes (3 or more) and then reconnect the power cable.
However, in order to provide full synchronization to the coaxial
network, disconnecting and reconnecting the power may be
required.