NETWORK SETTINGS
Static WAN with LAN IPv6 Stateless Settings
1. To configure IPv6 LAN Stateless mode with StaticStatic WAN,
select the StatelessStateless option on the IPv6 Configuration IPv6 Configuration
ControlControl page as shown below:
2. Specify the settings to be used to assign LAN IPv6
addresses by entering the following details:
• IPv6 LAN ConfigurationIPv6 LAN Configuration (select Stateless from the
dropdown list)
• LAN Prefix LAN Prefix (automatically populated)
• IPv6 LAN Address IPv6 LAN Address (automatically populated)
• LAN Link Local AddressLAN Link Local Address (automatically populated)
• Subnet IDSubnet ID - set the site topology for your internal site
• Router Advertisement LifetimeRouter Advertisement Lifetime (minutes between 0-150)
To Next Page
Loading...
