Vermona meloDICER - To Dice or not to Dice

To Dice or not to Dice
There are two more essential control elements of the rhythm- and melody section: The DICE buttons.
Did you already hit one or both of them? If not, just do it. With each press, meloDICER generates new random
values for the rhythm respectively the melody section. We call that behavior dice-mode.
The counterpart of dice-mode is realtime-mode. Press and hold one or both DICE buttons for a second until the
corresponding LED goes off. MeloDICER leaves dice-mode and enters realtime-mode.
In realtime-mode, there is no repeated pattern. MeloDICER continuously generates new random values, based on
the parameters you set for the corresponding section.
To re-enter dice-mode, hit DICE again.
☞
Whenever you re-enter dice-mode, you will get the same random values that you
had before leaving it. Thus you can play a pattern, change to realtime-mode to get
some variations and go back to the original pattern.
With separate DICE buttons for rhythm and melody section, you can i.e. generate
a repeated pattern for the rhythm while the melody continuously plays random
notes.
11