LOCK-Mode
All adjustments of the rhythm- and melody sections are instantly applied. The stochastic engine reacts as soon as
you turn a knob or move a fader. Thus, meloDICER can be treated as an instrument. You can and should play the
module’s control elements.
On the other hand you might want meloDICER to play a pattern while you already prepare new settings for
rhythm and or/melody changes. Luckily we implemented lock-mode for that purpose.
Press LOCK to activate lock-mode; the red LED goes on. As long as lock-mode is active all control elements of the
rhythm and melody section as well as FIRST STEP (4) and LAST STEP (6) are now decoupled from the stochastic
engine. The adjustments you make do not have an immediate impact. To apply the settings leave lock-mode by
pressing LOCK again.
☞
If you have a MEX3 module connected to your meloDICER, lock-mode also
applies for incoming MIDI Control Change messages (see "MEX3" on page 26 and
"MIDI IN channel (9-A)" on page 31
).
14 User Guide meloDICER & MEX3
To Next Page
Loading...