Preparations
Probably you changed some settings when discovering the surface of meloDICER. To make sure, that your
module behaves as expected reset it to factory defaults.
Reset to factory defaults
1. Make sure your modular system respectively the module is not powered.
2. Press and hold both DICE buttons while powering the module. Watch the little lightshow around the rotary
encoder. Once all LEDs light up, you can release the buttons.
☞
A factory reset will not affect saved patterns. It only applies to edit-parameters
and dice-mode state.
If you like to clear the pattern memory as well, press the rotary encoder and LOCK
when powering meloDICER. The lightshow is even more spectacular.
Basic settings and connections
In order to follow this tutorial you will need a synthesizer voice with at least an oscillator and a VCA, modulated
by an envelope generator with a sustain-phase.
Connect GATE OUT to your envelope generator’s input and 1V/OCT to the oscillators corresponding CV-input.
Please set your meloDICER’s knobs and faders like on Figure 1: MeloDICER with basic settings on page 6.
5
To Next Page
Loading...