Modes
You can use meloDICER in four different ways. It has two sequencer- and two quantizer-modes. To change the
mode follow these steps:
1. Press and hold E for one second.
2. When the red LED is blinking you can select the desired mode A, B, C or D.
3. The new mode is instantly applied. The yellow LED next to the buttons A, B, C and D shows the current mode.
Read on to find a short explanation of the four modes.
A - Sequencer (meloDICER)
This is the standard meloDICER mode. All functions that you learned about in the manual so far work in this
mode.
☞
EDIT-parameters as well as saving and loading patterns are only available here.
B - Seq + Gate
This mode only uses the melody section as well as LEGATO and REST of the rhythm section. The module doesn’t
generate an own rhythm, instead you will have to feed it with gate signals using the GATE IN 1 input.
The module generates a control voltage at 1V/OCT based on the settings of note- and octave range faders with
each incoming gate signal.
23
To Next Page
Loading...