Vermona meloDICER - C - Quantizer 1; D - Quantizer 2

☞
This mode can be used to alter rhythms that you get from another module, i.e. a
randomRHYTHM. You can also use it to pair two meloDICER modules for
duophonic melodies with the same rhythm base.
C - Quantizer 1
In this mode meloDICER works as quantizer for external CV signals. It works with voltages between 0 and 5 volts
at CV IN 2. The faders of the melody section define your scale. The higher a fader is raised, the wider its
quantization range.
The quantized voltages are available at 1V/OCT. The module quantizes on quarter notes (clock in respectively the
red LEDs around the rotary encoder). The pattern length can be adjusted by setting up first and last step (see
Pattern Length on page 9).
D - Quantizer 2
This mode works similar to quantizer mode 1 but with external gate signals at GATE IN 2. As long as GATE IN 2
gets a gate signal, the voltage at CV IN 2 will be quantized and output at 1V/OCT.
24 User Guide meloDICER & MEX3