Advanced Functions
Pattern Length
Until now our pattern had a length of four quarter notes which marks the maximum length. You can set the first
and last step with a resolution of 1/16 and with that the pattern length.
Setting first and last step
Before proceeding, make sure to activate dice-mode for the rhythm and melody section.
To the right of the rotary encoder you will find the buttons for the first 4 and last 6 step. If you hold down one of
these, the LED around the rotary encoder shows the first (1) resp. last (16) step. For changing that, just turn the
rotary encoder while still holding down FIRST STEP (4) or LAST STEP (6).
With release of the knob, the new position is assigned.
☞ You cannot set the last step before the first step.
Moving the sub-range
If your range is less than 16/16, you can move the sub-range within the maximum length of four quarter notes.
Just press and hold both buttons, FIRST STEP (4) and LAST STEP (6) while turning the rotary encoder. When
releasing the buttons, the new position is applied.
Returning to maximum length
If you’d like to quickly return to base settings (step 1 and 16), hold FIRST STEP (4), LAST STEP (6) or both while
pushing the rotary encoder.
12 User Guide meloDICER & MEX3
To Next Page
Loading...