Restart
With a push on the rotary encoder (without pressing any other button), you can reset the pattern. This means,
that it restarts from the first step with the next internal or external clock signal.
☞
This function can also be triggered with an external trigger signal on GATE IN 1
(see "Configuring the gate inputs" on page 20).
Mute
MeloDICER does not have a start, stop or continue button, it is always running. You can however mute GATE
OUT. The sequencer is still running but doesn’t generate any gate event.
You can manually activate mute by pressing M (button B). As long as mute is active, the yellow LED next to M is
blinking.
With edit-parameter 5 you can select if leaving mute instantly opens GATE OUT again (option A) or if it resets the
pattern and opens GATE OUT with the next internal or external clock signal (option B) — see "MUTE-Mode (5-A
and 5-B)" on page 21.
Mute can be configured being active when powering the module. This might be useful if you don’t like that your
modular system instantly starts playing melodies after you switched it on (see "MUTE-Mode (5-A and 5-B)" on
page 21).
You can also activate/deactivate mute with a gate signal on GATE IN 2 (see "Configuring the gate inputs" on page
20
).
13
To Next Page
Loading...