MEX3
MEX3 is a MIDI interface for meloDICER. This might not sound very spectacular, but it remarkably extends
meloDICER’s application possibilities, beside offering full integration with any MIDI setup. The combination of
both modules provides the following features:
• Send sequences as MIDI notes
You are not limited to your modular system anymore. You can directly sequence any MIDI synthesizer without
the need of CV/Gate-to-MIDI converters.
• Polyphonic Sequences
Sequences being sent via MIDI can have up to three-voice polyphony. You can set the probability for the
appearance of additional notes.
• Receive MIDI Control Change Messages
All parameters of meloDICER respond to MIDI Control Change messages. Thus, you can automate all
movements with your DAW or send controller snapshots for chord changes, probability alterations, etc.
• Send MIDI Control Change Messages
All buttons, faders and knobs of meloDICER can send MIDI control change messages. This allows you to record
movements with any MIDI sequencer or control a second meloDICER for parallel chord progressions.
• Receive and Send MIDI Clock
You can directly synchronize meloDICER to your MIDI setup without the need for additional clocking modules.
• START, STOP and CONTINUE
With MEX3, your meloDICER understands these MIDI realtime controls. You will never be out of sync with
your whole project.
26 User Guide meloDICER & MEX3
To Next Page
Loading...