Setting REST2 and REST3
You can set the REST probability for voice 2 and voice 3 on your meloDICER with edit-parameters 10-A (REST2)
and 10-B (REST3):
1. Enter the edit menu by pressing E
2. Select edit-parameter 10 by turning the rotary encoder until the LED labeled with 10 lights up.
3. Press and hold button A for REST1 or B for REST2 while setting the desired value using the rotary encoder.
New values will immediately be applied.
4. Leave the edit menu by pressing E again.
You can also set REST2 and REST3 via MIDI Control Change messages. For more information about that, see
"MIDI Implementation Chart" on page 34.
Velocity and Accent
You can set the standard velocity value for MIDI notes with edit-parameter 10-C from 16 to 104. To bring more
dynamic into your sequences, we introduced ACCENT probability (edit-parameter 10-D). The higher you set
ACCENT probability, the more notes will be played with maximum velocity (127).
Velocity and ACCENT can also be controlled by MIDI Control Change messages ("MIDI Implementation Chart" on
page 34).
30 User Guide meloDICER & MEX3
To Next Page
Loading...