VXA-300 PILOT III OPERATING MANUAL
47
MENU
(
“SET”
)
MODE
05
[
BEEP
]
Function: Keypad Beeper On/Off.
Available Values: on/DTM/oFF
Default Setting: on
on: Sounds a beep corresponding to a musical note.
DTM: Sounds a beep corresponding to a DTMF tone.
off: Disables the key beeper.
If you do a lot of scanning, you may wish to set this Menu
item to “oFF,” as the Beeper will be heard each time the
scanner pauses.
06
[
RSAV
]
Function: Selects the Receive-mode Battery Saver “sleep”
ratio.
Available Values: 1:1 ~ 1:5/oFF/ABS
Default Setting: 1:1
The setting of 1:5 will promote the greatest conservation
of battery capacity, but the receiver’s response time to in-
coming calls will be slowed somewhat.
ABS: Automatic Battery Saver, based on activity on the
receiver.
Note: This feature does not operate during Scan or Dual
Watch.
07
[
LAMP
]
Function: Display and Keypad Illumination Mode.
Available Values: KEY/oFF/CNT
Default Setting: KEY
“KEY” mode: The illumination lamp will be activated for
5 seconds when any front panel key or the
VOLUME knob is pressed, or if the DIAL
knob is rotated.
“oFF” mode: Disables the illumination lamp.
“CNT” mode: Illuminates the Display/Keypad continu-
ously.
08
[
SFT
]
Function: CPU Clock Shift.
Available Values: on/oFF
Default Setting: oFF
This function is only used to move a spurious response
“birdie” should it fall on a desired frequency. Consult your
Vertex Standard dealer for details regarding this function.
09
[
PRTM
]
Function: Selects the Priority Checking Time.
Available Values: 05/10/15/20/25/30 (
0.5/1/1.5/2/2.5/3 sec.
)
Default Setting: 20 (2 seconds)
This Menu item allows you to define how often the Prior-
ity Channel will be checked for activity.
Note: The Dual Watch Polling time is 500 mS (fixed).
To Next Page
Loading...
Need help?
General
