Vertex Standard Pilot III User Manual

VXA-300 PILOT III OPERATING MANUAL
49
MENU
(
“SET”
)
MODE
14
[
TEMP
]
Function: Correcting the thermometer setting.
Available Values: –127 ~ +127 (x0.1 °C)
Default Setting: 000 (ºC)
This allows you to calibrate the internal thermometer with
a known-to be-accurate source.
15
[
UNIT
]
Function: Selects the measurement units for the tempera-
ture sensor.
Available Values: °F/°C
Default Setting: °F
16
[
TOT
]
Function: Setting of the Time-Out Timer countdown time.
Available Values: 1/3/5/oFF (minutes)
Default Setting: oFF
The Time-Out Timer shuts off the transceiver after con-
tinuous transmission exceeds the programmed time.
17
[
DIMM
]
Function: Setting of the display brightness level.
Available Values: LV1 ~ LV4
Default Setting:LV3
18
[
KEY1
]
Function: Programming the primary (momentary press
mode)
[
USER
]
key assignment.
Available Values: no/ANL/PA/PIT
Default Setting: ANL (Automatic Noise Limiter)
See page 41 for details.
19
[
KEY2
]
Function: Programming the third (press and hold mode)
[
USER
]
key assignment.
Available Values: no/ANL/PA/PIT
Default Setting: PA (Public Address)
See page 41 for details.

Vertex Standard Pilot III Specifications

General

Brand	Vertex Standard
Model	Pilot III
Category	Transceiver
Language	English