PROPRIETARY NOTICE
The information contained in this publication is derived in part from proprietary and patented data of METTLER TOLEDO. This
publication shall not be copied in whole or in part without prior written approval of METTLER TOLEDO, nor shall it be used for
any purpose other than that intended. This document is subject to change without notice.
STANDARD WARRANTY
METTLER TOLEDO warrants that the equipment covered by this warranty will be free from defects in workmanship and material
for two years from date of installation or twenty-six (26) months from date of shipment to the buyer, whichever comes first.
Should any such defects be found and reported during the first thirty (30) days after installation (if installation occurs during
the warranty period), METTLER TOLEDO (herein referred to as the “Company”) will, at its option, refund the purchase price or
correct such defects, furnishing replacement parts and service free of charge to the buyer. For the remainder of the first 12
months of the warranty term, the Company will furnish necessary replacement parts and on-site technician’s service free of
charge, provided the Buyer agrees to pay reasonable technician’s travel time, vehicle mileage, and associated travel expenses
to and from the nearest authorized Company service location. If the equipment is covered by a two-year warranty, for the last
12 months or remaining balance of the warranty period, whichever comes first, the Company will furnish the necessary
replacement parts to the Buyer free of charge, provided that the Buyer agrees to pay reasonable technician’s on-site labor
services, travel time, mileage, and expenses to and from the nearest authorized Company service location. The following are
NOT covered under any of these warranties:
1. Initial installation and ongoing scale calibration.
2. Damage to scale components by gross abuse, fire, flooding, explosion, water, voltage surges, or civil disturbance.
3. Normal maintenance or consumable items.
This warranty covers only Model 2158, 2160, and 2162 VERTEX floor scales. Refer to METTLER TOLEDO Standard Product
Warranty for coverage of other scale system components, including scale instrument, printer, and/or other accessories.
THE COMPANY EXPRESSLY WARRANTS THE EQUIPMENT MANUFACTURED BY IT AS SET FORTH HEREIN. THE COMPANY
MAKES NO OTHER WARRANTIES EITHER EXPRESSED OR IMPLIED (INCLUDING WITHOUT LIMITATION WARRANTIES AS TO
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE). IN ADDITION, THIS DOCUMENT SHALL CONSTITUTE THE SOLE
AND EXCLUSIVE REMEDIES OF THE BUYER FOR ANY BREACH BY THE COMPANY OF ITS WARRANTIES HEREIN.
COMPANY LIABILITY UNDER THIS WARRANTY OR ANOTHER WARRANTY, WHETHER EXPRESSED OR IMPLIED IN LAW OR
FACT, SHALL BE LIMITED TO THE REPAIR OR REPLACEMENT OF DEFECTIVE MATERIAL AND WORKMANSHIP, AND IN NO
EVENT SHALL IT BE LIABLE FOR CONSEQUENTIAL OR INDIRECT DAMAGES.
This warranty coverage is applicable only to the United States of America.
Export Products: The Company warrants equipment destined for export or sold for export to be free from defects in
workmanship and material for a period of one year from date of installation or 18 months from date of shipment to the Buyer,
whichever occurs first. Should any such defect be found within that period, parts will be furnished free of charge (ex works)
point of origin or final distribution center. If the Buyer requests the performance of warranty work provided for under the
foregoing warranty outside of the contiguous United States, the Buyer shall be required to pay for labor, travel time, living, and
travel expenses of any personnel required to perform such warranty work.
APPLICATION GUIDES
The only warranty of METTLER TOLEDO is for the product it supplies under the Product Warranty Statement listed above.
Weighing application guidelines pertain to METTLER TOLEDO products.
To Next Page
Loading...
General