Edge 700 Phone - 24 Button 6-9
About Wave Digital Phones
Wave Phone User Guide
Feature Keys & Functions
Feature Used to …
1
Handset answer or place an internal or external call.
2
Speaker hear the other party during a call without using the handset or
headset (Speaker Mode).
3
Flat (Ribbon) Cable Connector
connect a Bluetooth® or Duplex module.
4
Display view information about the options and status of your phone.
5
Message Waiting Light indicate when you have a new voicemail message.
6
Softkeys (Three) make selections from the display.
7
Pre-programmed (PGM) Buttons
(Twenty-four)
perform special phone functions (pre-programmed by the
System Administrator).
8
Microphone speak to a caller when using the speaker instead of holding the
handset.
9
TAP Button reconnect (or toggle between) calls on hold, during call transfer,
and when creating conference calls. Also, while dialing,
pressing this button once will erase the last dialed digit and
pressing it twice will clear all the dialed digits.
10
TRANS Button put a call on hold while you dial the destination extension
number when transferring call.
11
SHIFT Button access a second level of AutoDial buttons.
12
MUTE Button prevent the distant party from hearing any conversation at
your end.
13
Scroll and Select Button(s) scroll through menu options and select items shown on
the display (see page 6-25).
14
Volume Up/Down (-/+) Buttons decrease/increase the loudness of the speaker or handset while
on a call, or the ringer when not on a call.
15
HOLD Button place a call on hold and keep the party connected while you
hang up or use other phone features.
Note: If more than one call is on hold, and you are not
currently connected to a call, you can press this button
to scroll through a list of calls on hold; press Tap to
connect to the displayed call.
16
SPEAKER Button switch to Speaker mode to hear a caller instead of holding
the handset.
17
Headset (2.5mm) Jack speak to a caller when using a headset instead of holding
the handset.
To Next Page
Loading...
