Flash 3-32
Using Wave Phone Features
Wave Phone User Guide
DIGITAL PHONES
The Do Not Disturb pre-programmed button on your phone is set up by your System
Administrator.
To Enable Do Not Disturb
Press the pre-programmed Do Not Disturb button.
The Do Not Disturb red LED lights, and
DND is displayed.
If your phone does not have a programmed Do Not Disturb button, dial *41.
Note: When you go off hook you receive "stutter" dial tone to indicate your phone is in a
special state.
To Cancel Do Not Disturb
Press the pre-programmed Do Not Disturb button.
The Do Not Disturb LED goes out.
If your phone does not have a programmed Do Not Disturb button, dial *42.
Note: You can also enable/disable DND using the display:
Press
MENU, then press NEXT three times.
Select
DND.
Select
On/Off.
Press
Done or SPEAKER end.
Flash
About Flash [ALL]
The Flash button is utilized in many of the features of this phone (such as when making calls,
transferring calls, or placing calls on hold). It is often used in conjunction with “feature codes”
(see Feature Code Reference lists at the end of chapters 4 through 6 of this guide).
• The location of the Flash button may vary from model to model. Your phone may have
button labeled Flash. However, it might have a button labeled Link or Call Waiting.
Check the diagrams of the various models in Chapters 4 though 6 of this guide according
to the type of phone you are using (SIP, digital, or analog).
To Next Page
Loading...
