Vertical Wave Phone - Page 143

Impact SCS (8012) - 12 button 6-11
About Wave Digital Phones
Wave Phone User Guide
Feature Keys & Functions
* While this digital phone model has an Intercom button, that button is used as a
primary line button, not for specific “Intercom” functionality.
Feature Used to …
1
Handset answer or place an internal or external call.
2
Speaker hear the other party during a call without using the handset or
headset (Speaker Mode).
3
Display view information about the options and status of your phone.
4
Softkeys (Three) make selections from the display.
5
Pre-programmed (PGM)
Buttons (Twelve)
perform special phone functions (pre-programmed by the
System Administrator).
6
SHIFT Button access a second level of AutoDial buttons.
7
Mute Button prevent the distant party from hearing any conversation at
your end.
8
SPEAKER button switch to Speaker mode to hear a caller instead of holding
the handset.
9
Volume Up () Button increase the volume of the speaker or the handset during a call.
10
Microphone speak to a caller when using the speaker instead of holding
the handset.
11
INTERCOM* access the primary line.
12
TAP Button reconnect (or toggle between) calls on hold, during call transfer,
and when creating conference calls. Also, while dialing, pressing
this button once will erase the last dialed digit and pressing it twice
will clear all the dialed digits.
13
Volume Down ( ) Button decrease the volume of the speaker or the handset during a call.
14
HOLD Button place a call on hold and keep the party connected while you hang
up the handset or use other phone features.
15
TRANS/CONF Button place a call on hold while you dial the destination extension number
when transferring calls or creating conference calls.
16
Headset (auxiliary) Jack speak to a caller when using a headset instead of holding
the handset.
Release 1.5 SP2
June 2009