Headset 3-39
Using Wave Phone Features
Wave Phone User Guide
Programming the Phone for Bluetooth® (Edge 700 - 24 button model only)
IMPORTANT: In order to use a Bluetooth® with the Edge 700 - 24 button phone, a Bluetooth®
module must be connected. In addition to the settings shown below, there are
Bluetooth®-specific operations that may be required. Consult your Bluetooth® user
documentation for details regarding installation of the module, as well as any other
programming settings required for optimum operation of the Bluetooth® device.
Some Bluetooth® headsets will shut off when placed in their charging cradle. If you are using
an Edge 700, and this occurs, turn the Bluetooth® headset on, then toggle the headset button.
Once the Bluetooth® module is connected
1. Press the MENU softkey until the Bluetooth® option appears.
2. Press the softkey that corresponds to the option you want to use (that is, 2.5mm
or Bluetooth®).
Note: If you choose the Bluetooth® option, the Bluetooth® device must be paired
(registered) to its “base station”. If/when you change Bluetooth® units, you will need to
unpair the current Bluetooth® unit, then pair the new unit.
When performing the Bluetooth® pairing or unpairing, it is recommended that the
headset be within three feet of the phone base.
3. Enter a 1 to “pair” the Bluetooth® device
4. Enter the Bluetooth® device code (four digits).
Hint: This information is probably located somewhere on the Bluetooth® packaging or
user documentation.
Once you enter the device code, the system will search for the device and, if successful, a
“Device registered” will be displayed.
5. Press the
EXIT softkey.
To Unpair the Bluetooth®
Follow steps 1 and 2 above, then in step 3, select 2 to “unpair” the Bluetooth® device. The
system will search for the device and, if successful, a “
DEVICE DE-REGISTERED” will be displayed.
To Next Page
Loading...
