ABOUT Screen
Select M AIN MEN U> ABO UT to enter the ABOUT screen. The ABOUT screen displays UPS model,
serial number, software version and hardware version.
Network
Select M AIN MEN U > N ET W O R K to enter the NETWORK screen.
The NETWORK screen displays the MAC address and the IPv4 IP address. If the GXT4 is fitted with
an optional Liebert IntelliSlot Web card (Liebert IS-WEBCARD), the screen will display IPv6 IP
address settings (IPv6 requires configuration).
4.5 Prompt List
A prompt screen is displayed during the operation of the system to alert you to certain conditions and/or
to require your confirmation of a command or other operation. See the following table for the prompts and
meanings.
PROMPT MEANINGS
Mains Power Restored The mains power returns and the UPS transfers back to mains (AC) mode.
UPS Return From A Low Battery Condition The UPS transfers back to mains (AC) mode from battery low mode.
UPS Return From Battery Mode The UPS transfers back to mains (AC) mode from battery mode.
UPS Self Test Successful The UPS self-test is successfully performed.
UPS Shutdown Command Received The UPS shut down was initiated through communication.
UPS Turn Off The UPS shuts down and has no output power.
UPS Turn On The UPS starts up successfully and supplies protected power to the load.
UPS Shutdown Process Had Been Cancelled The shutdown command sent through Liebert MultiLink or SNMP card to the UPS is canceled,
ECO Mode Enabled The UPS is configured to ECO mode operation,
ECO Mode Disabled The UPS is configured to Online mode, supplying protected power to the load through the inverter.
UPS Internal Temperature Return To Normal The internal temperature of the UPS recovers to normal range.
UPS Load Return From Overload The loads are reduced, and the UPS recovers to normal state from overload.
Load On Inverter The inverter is on and supplies protected power to the load.
Load On ECO Bypass The UPS is on ECO mode; the mains is supplying power to the load directly to reduce energy usage.
Bypass Power Restored The bypass power recovered and the UPS can now transfer to bypass.
Table 4.3 System prompts and meanings
Vertiv | Liebert GXT4 Installer/User Guide | 37
To Next Page
Loading...
