Vertiv Liebert PCW - Page 50

E - 1
Enclosure E - Accessories
Liebert PCW - UM - 273895 - 04.10.2018
E.1. Kit Legs (Not Available for PH 025 - 030) E.2. Baseframe
Legs kit can be supplied on request to support Liebert PCW when
installed with a raised oor. The legs are xed with the unit frame
and allow to support the unit at di󰀨erent height, three kits are avail-
able with di󰀨erent height: adjustable in the range: h1- 30- 370 mm;
h2 370- 570 mm; h3 570- 800 mm.
A base frame can be supplied on request to support Liebert PCW
when installed with a raised oor. The frame could be regulated
with a height form 120 mm to 800 mm and the unit is xed on it.
The unit must be xed with 4 screws on the base frame,
the screws are not supplied with the unit.
E.3. Base module E.4. Base Module h 600mm with rear air intake
A 200 mm high base module can be supplied on request to support
Liebert PCW Upow and at the same time allow pipework to enter
the base of the unit when a raised oor is not installed.
The unit must be xed with 4 screws on the base mod-
ule, the screws are not supplied with the unit.
A base module h 600 mm can be supplied on request to allow Lieb-
ert PCW Upow to work with a rear air intake.
These accessory at the same time support the allowing the piping
connection when a raised oor is not installed. Note that in this
case the air conditioning unit must be ordered with a blind front
panel.