EasyManua.ls Logo

Vespa LX 50 4T - Engine Start-up and Running-in Protocol

Vespa LX 50 4T
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
02_02
Running in (02_02)
WARNING
DURING THE FIRST 1000 KM DO NOT RIDE THE VEHICLE OVER 80% OF ITS
MAXIMUM SPEED. AVOID TWISTING THE THROTTLE GRIP FULLY OR KEEP-
ING A CONSTANT SPEED ALONG LONG SECTIONS OF ROAD. AFTER THE
FIRST 1000 KM, GRADUALLY INCREASE SPEED UNTIL REACHING THE MAX-
IMUM PERFORMANCE.
02_03
Starting up the engine (02_03)
The vehicle is fitted with direct drive automatic transmission. Therefore, always start
the engine with the throttle grip slightly twisted; to start-off from still, progressively twist
the throttle grip.
The vehicle is equipped with a fuel valve and a starter that switch on automatically as
soon as the engine is started.
To start it up, it is necessary to:
1: Put the motorscooter on its stand "E"; check that the rear tire is off the ground.
2: Keep the throttle grip slightly twisted.
3: Insert the key in ignition switch «D» and turn it to «ON»; when turning the key to
«ON», the fuel reserve warning light turns on for a few seconds indicating the correct
functioning of the bulb.
4: Push the starter button «A» after pulling the rear brake lever « or the front brake
lever «C».
18
2 Use

Related product manuals