Vespa LX 50 4T User Manual

Scheduled maintenance table
Adequate maintenance is fundamental to ensuring long-lasting, optimum operation
and performance of your vehicle.
To this end, a series of checks and maintenance operations (at the owner's expense)
have been suggested, which are included in the summary table on the following page.
Any minor faults should be reported without delay to an Authorised Service Centre
or Dealer without waiting until the next scheduled service to solve it.
All scheduled maintenance services must be carried out at the specified times, even
if the stated mileage has not yet been reached. Carrying out scheduled services on
time is necessary to ensure your warranty remains valid. For any further information
concerning Warranty procedures and "Scheduled Maintenance", please refer to the
"Warranty Booklet".
EVERY 3,000 KM
Engine oil - level check/ top-up
EVERY 2 YEARS
Brake fluid - change
AFTER 1,000 KM OR 4 MONTHS
Hub oil - change
Valve clearance - check
Idle speed (*) - adjustment
Throttle lever - adjustment
56
6 Programmed maintenance

Vespa LX 50 4T Specifications

General

Engine Type	Single-cylinder, 4-stroke
Displacement	49.9 cc
Cooling System	Air-cooled
Fuel System	Carburetor
Front Brake	200 mm disc
Rear Brake	110 mm drum
Front Tire	110/70 - 11"
Rear Tire	120/70 - 10"
Height	1, 140 mm
Transmission	Automatic
Fuel Tank Capacity	7 liters
Seat Height	785 mm
Dry Weight	96 kg
Max Power	4.35 hp @ 8, 250 rpm
Length	1, 770 mm
Width	705 mm
Front Suspension	Single arm with helical spring and hydraulic shock absorber