Service Manual Indicator JIK-6 Page 8
conditions for appearance of
stable symbol.
: ~ Display when variation is within 2e~8e
:
One-way transmission (output)
A10
RS232-Receiving Port
Selection
Overview: To select one-way
or two-way transmission.
: Two-way transmission (output/input)
: Initiation Delay function off.
: . Signal sent out in 0.5sec.
A11
Initiation Delay
Overview: RS232 sends out
signal several seconds after
stable appearance of stable
symbol.
: ~
Signal output in 1sec., 2 sec…4 sec.
: Weight memory function off.
A12
Weight Memory
Overview: To record the last
weighing value.
:
On (The function is applicable for
production line)
: No limit
A13
Min. Internal Use Limit
Overview: To limit sensor use
rate.
: L/C use rate at least over 60%
: Weight display function not in use.
A14
Calibration Mode-Weight
Display
Overview: No need to restart
the machine after calibration.
: In use.
:
A15
Enlargement Ratio Selection
Overview: To adjust ratio of
internal value to external
value.
:
:
Starting time is year 2000 but without
RTC detection function
:
A16
Starting Year Setting
Overview: Since RTC
calculation time is around 15
years, this setting may avoid
occurrence of problems similar
to Y2K.
:
~
The starting time calculation is based on
a scale of 4 years; you may select
between 2008~2100.
Note: Items marked with an asterisk () stand for factory settings.
To Next Page
Loading...