Mastertech 3100 Operator’s Manual Page 7-1
7. FINISHING UP
After using the Mastertech, a few simple steps will help you leave the vehicle electronic system(s) in the
proper state and also ensure that you get the most use out of your diagnostic tools:
1. Reconnect all hoses, connectors, spark plug wires, fuel lines, etc. that were disconnected from the vehicle
during testing.
2. Before turning the tester off, clear any Diagnostic Trouble Codes that may have been set during the
course of troubleshooting the vehicle electronic system(s).
3. Remove power to the tester by unplugging the DC power cable.
4. Disconnect the tester's connecting cables from the vehicle.
5. Turn the tester off by pressing P X .
6. The program card and/or cartridge may be stored in the tester, or removed and stored in the program card
slot in the storage case.
7. Inspect the cables, connectors, and cigarette lighter for damage and corrosion. Replace faulty components
immediately.
8. Store the Mastertech, cables, and adapters in the storage case.
CLEANING AND STORING YOUR TESTER
If the Mastertech, test leads, adapters or cables become dirty, they may be cleaned by wiping them with a rag
lightly coated with a mild detergent or non-abrasive hand soap. Do not immerse the tester, test leads,
NOTE
If the Mastertech is turned on without a program card or cartridge
installed, or with a different program card or cartridge installed, the data
stored in the tester memory, such as Snapshot data, will be lost.
To Next Page
Loading...
