SET BLOWING PARAMETERS.
In the Paragraph Settings submenu, select Blow Settings to display the left
interface:Select and adjust parameters by pressing the arrows. When
you're done adjusting, move the cursor to Write and press ENT to save the
parameter changes, or press ESC to exit without saving. Reading can load
saved parameters.
ADJUST THE RESET SPEED.
In the "Parameter Settings" submenu, select "Speed Settings" to display
the left inter-face:
Select and adjust parameters by pressing the arrows. When you're done
adjusting, move the cursor to Write and press ENT to save the parameter
changes, or press ESC to exit without saving. Reading can load saved
parameters.
To Next Page
Loading...
