Operation
40
The following instructions should be complied with:
• Check all points mentioned in the “maintenance” section.
»Specific safety information« page 54
»Lubrication safety and use of oil« page 54
• Check knives are not worn down. The knives can be turned so they
rotate in the opposite direction.
»Knives« page 65
The machine is operated in the following way:
Make sure that there are no persons in the surrounding area.
Activate the tractor's hydraulics and the pull the machine's cutting
unit together to release the transport lock.
Pull in the cord and activate the tractor's system and let the
machine's cutting unit swing down into the working position.
Ensure that all of the machine's guards are locked and correctly in
position.
Carefully connect the tractor's PTO shaft.
Carefully increase the speed of the PTO shaft to 540/1000 rpm.
»Checking the rpm« page 30
Start the tractor’s forward drive.
If none of the machine's functions are working:
Stop the tractor’s forward drive.
Stop the tractor.
Disconnect the PTO shaft immediately.
Disconnect the tractor's hydraulic system immediately.
If the machine is too noisy or vibrates too much, stop the machine
immediately.
»Troubleshooting« page 103.
To Next Page
Loading...
