Maintenance
101
Transmission - rollers
Safety concerning maintenance work with the transmission
When working on the transmission the tractor must be stopped and
secured.
This prevents the machine from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected following the
instructions, serious accidents causing damage to limbs can occur.
When working on the transmission:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The PTO shaft must be disconnected.
• The tractor hydraulic system should be disconnected.
• The hand brake should be activated.
V-belt
After 10 working hours
Thereafter, every 40 hours
of use
»Maintenance intervals« page 73
The V-belts on the rollers must be checked regularly.
The V-belt for the roller transmission is checked as follows:
> The springs are tightened with a bolt to the measurement shown.
NB
A new machine or a newly fitted V-belt should be checked after a few
hours use.
To Next Page
Loading...
