UniOP
2
The products have been designed for use in an industrial environment in compliance
with the 2004/108/EC EMC Directive.
The products have been designed in compliance with:
EN 61000-6-4 EN 55011 Class A
EN 61000-6-2 EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
The installation of these devices into the residential, commercial and light-industrial
environments is allowed only in the case that special in measures are taken in order to
ensure conformity to EN 61000-6-3.
The products are in compliance with the Restrictions on Certain Hazardous
Substances (RoHS) Directive 2002/95/EC
In compliance with the above regulations the products are CE marked.
Product Identification
The product may be identified through a plate attached to the rear cover. You will
have to know the type of unit you are using for correct usage of the information
contained in the guide.
An example of this plate is shown in the figure below:
eTOP33C-0050 product model name
06/08 month/year of production
13435 35508 serial number
H/W V hardware version of the product
S/W V software version of the product
To Next Page