What to do if Videx Intercom System external call works but communication fails?
If your Videx Intercom System's external call works but the communication fails when answered, the cause may be that the cable size is too small. The suggested solution is to increase the cable size or double up using two wires for each signal.
Why can't I open the door during Videx Intercom System conversation?
If you are unable to open the door during a conversation on your Videx Intercom System, it is possible that the cable size is too small. To resolve this, increase the cable size or double up using two wires for each signal.
Why is there speech only from outside to inside on Videx Intercom System?
If you are experiencing speech only from outside to inside on your Videx Intercom System, it could be due to wire 2 being broken or shorted. Check the connection of wire 2 to resolve this issue.
How to increase low speech volume on Videx Intercom System?
If you're experiencing low speech volume on your Videx Intercom System, the volume trimmers on the door station may need adjustment. Adjust the trimmers until you reach the desired volume level.
Why does Videx Intercom System external call work, but communication fails when answered?
If the external call on your Videx Intercom System works but the communication fails when answered, it is possible that the cable size is too small. To solve this, increase the cable size or double up using two wires for each signal.
Why does Videx VK4KC intercommunicating call not work?
If the intercommunicating call on your Videx Intercom System does not work, it could be because the “Key” button was pressed a number of times different from the videophone address value. Check the address of the videophone you are calling and try again.
How to fix low volume of speech on Videx VK4KC Intercom System?
If you are experiencing low volume of speech on your Videx Intercom System, it could be that the volume trimmers of the door station require adjustment. Adjust the trimmers until the required volume is reached.
What to do if Videx Intercom System door station cannot call the extension?
If the Videx Intercom System door station cannot call the extension, and the bell LED is on for 2 seconds, it could be due to several reasons: * Incorrect wiring between the door station and the videophone. * Insufficient cable size. * Incorrectly programmed videophone address. * Changing the videophone address without powering down the system. To solve this: 1. Check the 6 common wire connections, especially wire “1” (speech line/data). 2. Increase the cable size or double up using two wires for each connection. 3. Verify the videophone address on the dip-switches. 4. Power down the system and then power it up again to detect the new videophone address.
Why does Videx VK4KC communication fail after answering an external call?
If external calls on your Videx Intercom System work initially but the communication fails upon answering, the issue might be due to an insufficient cable size. To resolve this, increase the cable size or double up using two wires for each signal.
How to fix bad video quality on Videx VK4KC Intercom System monitor?
If the video quality on your Videx Intercom System monitor is poor, and the image is distorted or doubled, it could be due to several reasons: * V1, V2 signals being unconnected, reversed, or shorted. * The switches of the two-way dip-switch not both being in the ON position. * V1, V2 of the last Art. 316N (if present) not closed with a 75 Ohm resistor. To fix this: 1. Check that the wires are not broken or shorted. 2. Set both switches to the ON position. 3. Use 2x 75 Ohm resistors to connect V1 & V2 to 0V.
General| Brand | Videx |
|---|---|
| Model | VK4KC |
| Category | Intercom System |
| Language | English |
To Next Page
