Videx VX2300 - Page 52

67009600-EN - Edition 2015 - Rev. 1.0
52
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
Art.KRV88-KRV86 3.5” Hands free videomonitor for VX2300 digital system
DURING THE CONVERASTION
During the conversation (Fig. 12):
• To switch from hands free to push to talk mode, keep
pressed the
until the related LED starts to ash slow-
ly (Fig. 13). Keep pressed the button to talk to the
visitor (the LED ashes quickly) and release the button
(the LED ashes slowly) to listen the visitor;
• To open the door press the button (Fig. 14)
• To enable the secondary service keep pressed the
button until the activation signals (call tone plus mes-
sage) are received (Fig. 15);
• To enable the BUS relay Art.2305 (if connected on the
pass) keep pressed the button until the display
shows the picture in Fig. 16 then select the BUS relay
to enable by the buttons and and conrm with
button.
• To enter into programming menu press the button
(Fig. 17).
ADJUSTMENTS MENU
In the programming menu you can set:
• The speech volume (8 levels, Fig. 17);
• The picture brightness (8 levels, Fig. 18);
• The picture contrast (8 levels, Fig. 19);
• The picture hue (8 levels, Fig. 20);
Adjust the selected option using the buttons
and
then conrm by the button to move to next option or use
the and buttons to navigate the options. With
“EXIT” selected, press to exit from the menu or
do adjust other settings.
15/12/11 14.5°C 09:23
MENU
PTT
Fig. 12
15/12/11 14.5°C 09:23
PTT
Fig. 13
15/12/11 14.5°C 09:23
MENU
PTT
Fig. 14
15/12/11 14.5°C 09:23
MENU
PTT
SRV
Fig. 15
15/12/11 14.5°C 09:23
MENU
PTT
SERV. - 1 + OK?
Fig. 16
OSD
EXIT
Fig. 17
OSD
EXIT
Fig. 18
OSD
EXIT
Fig. 19
OSD
EXIT
Fig. 20