Videx VX2300 - Art.2301 N Entrances Exchanger; Art.2301 N Entrances Exchanger Description; Art.2301 N Connection Terminals and Jumpers; Art.2301 N Specifications

5000 Series Videomonitor wall mounting instructions
67009600-EN - Edition 2015 - Rev. 1.0
32
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
5000 Series Videomonitor wall mounting instructions
1. To install Art.SL5456 it is necessary to open it. Follow picture Fig. 4: turn screw “G”, pull cover “D” and lift it up (or push it forward
if the videomonitor is in horizontal position), then disconnect plug “E” (Fig. 3) from plug “F” on the connection board housed
on the bottom “ A ”.
2. Leaving approximately 135cm from the nished oor, t the bottom “A” against the wall and mark the xing holes considering
that the cables must fed through the opening “H” (Fig. 2).
3. Make the holes, and x bottom “A” on the wall using the two wall plugs “B” and the two screws “C” as shown in Fig. 2.
4. Make all connections as per provided diagram.
5. As shown in Fig. 3, move cover “D” close to bottom “A”, connect plug “E” to plug “F” on the connection board then proceed
with the next step.
6. Hook cover “D” to bottom “A” by using the two clips “J” (Fig. 2) as shown in Fig. 4 then push down cover “D” towards bottom
“ A ”. Then proceed with system testing.
7. When nished the testing, x cover “D” at the bottom “A” using the screw “G” (Fig. 4).
135cm
Fig. 1
E
A
D
F
Fig. 3
B
B
J
H
A
C
C
Fig. 2
D
G
A
Fig. 4