Carousel Mate - Service Manual
Page 11
CarouselMate_sm-1300-01-Oct2014
Service: 1-866-821-2647
Oce: 1-800-210-0141
www.storevertical.com
OPERATING INSTRUCTIONS
Calibration Factors
Three screens present calibration factors� Your calibration factor has been factory pre-set to accurately mea-
sure carpet� This value should only be altered if you have product that has dierent measurement charac-
teristics than regular carpet� The screens Carpet1, Carpet2 and Vinyl are available� Only Carpet1 is used for
the Carousel Mate� The factory default setting accurately measures standard carpet without any alteration�
Enter New User Password
As the name suggests, this is where you can change the User Password� This is not the Master Password� To
disable the password feature, set this value to zero (it is recommended)� The default setting is ‘o’, and Vidir
recommends to leave this setting as ‘o’�
User password is not required unless activated� Factory Default is o�
Password Timer
Valid values are 0, or some number greater than 30� This number is the length of time in seconds the Carou-
sel Mate will wait after the last valid key press, before it will reset the machine and require a User Password
entry� A zero value here, disables the timer feature, and is the default setting�
To Next Page
Loading...