VIDIR CAROUSEL MATE - Preparations; Electrical Specifications; Grounding Instructions

Carousel Mate - Service Manual
Page 4
CarouselMate_sm-1300-01-Oct2014
Service: 1-866-821-2647

Oce: 1-800-210-0141

www.storevertical.com
Electrical Specications
Machine Power Requirements: Please see machine label for electric power requirements�
FEATURES:
This machine is equipped with a Master Switch� This switch is highly visible and easy to reach� It shuts o all
power to the carousel� Ensure the Master Switch is in the OFF position before working on the machine, to
prevent accidental operation of the machine�
NOTE:
All relays and transformers are located in the electrical box behind the control panel� These can be accessed
by removing the screws that secure the control panel cover to the box� Ensure the Master Switch is in the
OFF position before removing the control panel�
CAUTION:
If the motors start to overload and stop during the operation of the machine remove pressure from the
Push Button� Do not try to force the machine� Do not continue to activate and deactivate an overloaded
motor� This will cause excessive wear and motor overheating� Correct the load conditions on the machine
before trying again� Refer to the section on LOADING THE CAROUSEL�
ATTENTION:
This machine should have a dedicated circuit�
Grounding Instructions
This machine must be grounded� If it should malfunction or break down, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock� This product is equipped with a cord hav-
ing an equipment-grounding conductor and a grounding plug� The plug must be plugged into an appro-
priate outlet that is properly installed and grounded in accordance with all local codes and ordinances�
DANGER – Improper connection of the equipment-grounding conductor can result in a risk of electric
shock� Check with a qualied electrician or service person if you are in doubt as to whether the product is
properly grounded�
Do not modify the plug provided with the product� If it will not t the outlet, have a proper outlet installed
by a qualied electrician or service person�
This machine must be connected to a grounded metal, permanent wiring system, or an equipment-
grounding conductor must be run with the circuit conductors and connected to the equipment-grounding
terminal or lead on the product�
PREPARATIONS